| Materials:
1 each - 2X4 (stud) for the base.
2 each - 2X3X8 foot uprights
25' of chicken wire (3 foot wide roll)
2 each - 2" PVC pipe 10 foot section
Light fixtures, bulbs and wire/plug (for candles)
|
Tools:
Hammer/nails
Screw drive/screws
Hot glue gun / Glue
Wire Caps, Electrical tape, etc.
Drill
|
|
 |
Here you can see the big picture.
Wood frame, PVC arms, chicken wire to add bulk under
the burlap, PVC for the candles and the Giant skull. |
|
Here's a close up of the giant foam skull from
Bucky's Boneyard.
I added black light LED eyes from
Haunt Master Products.
|
 |
|
 |
This
slightly side view shows the construction. The candles were wired and candle
bulbs were placed at the top. Both plugs were run in the chicken wire and
connected to an extension cord in the chest area. The extension cord was run
out the base. |
|
Here's a pix with the burlap placed on
after it was dipped in the wall board mud that had been mixed with gray
paint.
You can see the candles with the bulbs
but the gloves have not been added. |
 |
|
 |
Close to finished with the gloves added. |
